//-------------------------------------------------------------------
// Filename: hal_mcu.c
// Description: 
//-------------------------------------------------------------------
//-------------------------------------------------------------------
// INCLUDES
//-------------------------------------------------------------------
#include "hal_defs.h"
#include "hal_clock.h"
#include "hal_mcu.h"
#include "hal_board.h"

//-------------------------------------------------------------------
// @fn          halMcuInit
// @brief       Set Main Clock source to XOSC
// @param       none
// @return      none
//-------------------------------------------------------------------
void halMcuInit(void)
{
    clockSetMainSrc(CLOCK_SRC_XOSC);
}

//-------------------------------------------------------------------
// @fn          halMcuWaitUs
// @brief       Busy wait function. Waits the specified number of microseconds. Use
//              assumptions about number of clock cycles needed for the various
//              instructions. This function assumes a 32 MHz clock.
//              NB! This function is highly dependent on architecture and compiler!
// @param       uint16 usec - number of microseconds delays
// @return      none
//-------------------------------------------------------------------
#pragma optimize=none
void halMcuWaitUs(uint16 usec)
{
    usec >>= 1;
    while (usec--)
    {
        NOP();
        NOP();
        NOP();
        NOP();
        NOP();
        NOP();
        NOP();
        NOP();
        NOP();
        NOP();
        NOP();
        NOP();
        NOP();
        NOP();
        NOP();
        NOP();
        //NOP();
    }
}

//-------------------------------------------------------------------
// @fn          halMcuWaitMs
// @brief       Busy wait function. Waits the specified number of milliseconds. Use
//              assumptions about number of clock cycles needed for the various
//              instructions.
//              NB! This function is highly dependent on architecture and compiler!
// @param       uint16 millisec - number of milliseconds delay
// @return      none
//-------------------------------------------------------------------
#pragma optimize=none
void halMcuWaitMs(uint16 msec)
{
    while (msec--)
    {
        halMcuWaitUs(1000);
    }
}

//-------------------------------------------------------------------
// @fn          halMcuSetLowPowerMode
// @brief      Sets the MCU in a low power mode. Will turn global interrupts on at
//             the same time as entering the LPM mode. The MCU must be waken from
//            an interrupt (status register on stack must be modified).
//              NB! This function is highly dependent on architecture and compiler!
// @param       uint8 mode - power mode
// @return      none
//-------------------------------------------------------------------
void halMcuSetLowPowerMode(uint8 mode)
{
    char buf[] = "LowPowerMode( )";
    buf[13] = mode + '0';
    // comment: not yet implemented
    HAL_ASSERT(buf);
}


//-------------------------------------------------------------------
// @fn  halMcuReset
// @brief
// Resets the MCU. This utilize the watchdog timer as there is no other way
// for a software reset. The reset will not occur until ~2 ms.
// NB: The function will not return! (hangs until reset)
// Parameters:
// @param  void
// @return void
//-------------------------------------------------------------------
void halMcuReset(void)
{
    const uint8 WDT_INTERVAL_MSEC_2 = 0x03; // after ~2 ms

    WDCTL = ((WDCTL &0xFC) | (WDT_INTERVAL_MSEC_2 &0x03));
    // Start watchdog
    WDCTL &= ~0x04; // Select watchdog mode
    WDCTL |= 0x08; // Enable timer
    while (1)
        ;
    // Halt here until reset
}